Should You Worry About Blood Clots During Periods

Blood Clots During Periods

blood clots in period are not unusual among women. Many women are scared and worried when they pass blood clots. But this can be normal, the amount and frequency of bleeding during periods vary. However, www.webmd.com suggests that it is a cause for concern and warrants a visit to the doctor when you are passing large blood clots for several hours or if your periods are heavy than usual.
Not many women or girls know what and whys of blood clots during periods and when you should visit a doctor. Read below to learn more.

Blood Clot – What is it
The human body produces anticoagulants. This chemical is also known as blood thinners as it prevents blood from becoming into a gel. During periods women experience blood loss, sometimes excessive. Menstrual blood clots are a natural way of keeping a control on the bleeding. This clot consists of clotted blood, endometrial tissue, and fibrin.

Reasons for blood clots during periods

Even Though blood clots are formed due to insufficient uterine strength, there are many other reasons for the formation of blood clots.
Obstruction in the uterus: There could be an obstruction in the flow of menstrual blood within the uterus due to fibroids, polyps, etc.
Adenomyosis: Sometimes the endometrium tissues start to grow within the muscles of the wall of the uterus. That results in excessive bleeding during periods, passing blood clots and also longer periods.
Endometriosis: The uterine lining thickens and causes heavy bleeding during periods which in turn causes blood clots during menstruation.
Post Childbirth Issues: After childbirth, uterus shrinks back to its normal size, but for some women, the uterus does not shrink back. That may cause the blood to clot inside the uterus before it is driven out during menstruation.

The heavy flow of blood during periods causes the uterus to accumulate blood within. When the blood fills uterus faster and is unable to expel it completely, blood pools and later becomes a clot.

Hormones: Progesterone and Estrogen are the two hormones that control how the lining of the uterus is shed. If they are not produced in appropriate quantity in the body, the endometrial lining of the uterus grows thick. This thick wall lining in the uterus can cause heavy bleeding during periods and also blood clots.

When to Visit your Doctor:
Larger than usual blood clots during periods
Frequency of passing of blood clots is very high in a small time frame
Mid-cycle bleeding or spotting
Severe cramps or pain during periods, long periods, excessive fatigue or massive blood loss

For many women, the blood clots may come in one cycle but not the next few cycles or not come again for an extended period. The cause for such behavior can be due to stress, lifestyle changes or dietary changes which might affect the lining in the uterus. Due to this variation in the thickness of the lining the bleeding during periods varies from cycle to cycle, when the bleeding becomes excessive it forms blood clots.
The passing of small bright red clots is nature’s way of cleansing your body.

The History of 3D Technology

3D technology can be tracked all the way back to the beginning of photography. In 1844 David Brewster invented the Stereoscope. It was a new invention that could take photographic images in 3D. Later, Louis Jules Duboscq took that innovation and improved on it. Louis took a photo of Queen Victoria using the improved technology and exhibited it at the Great Exhibition in 1851. This picture became very famous across the world. Steroscopic cameras began to catch on and became rather normal for individual use by World War II.

In 1855 the Kinematascope, a stereo animation camera, was devised. It was able to make 3d motion pictures. In 1915 the first anaglyph film was produced. Anaglyph technology utilized 3d glasses with two different color lenses which would guide an image to each eye. In 1890 William Friese-Greene, a British film leader, filed a patent for the 3D film procedure. In 1922 the first public 3D film, “The Power of Love”, was exhibited. In 1935 the first 3D Color film was created. Using the technology would stay dormant for more than a decade.

In the 1950s, 3D technology made a return. During this age, TVs had become extremely popular and had began appearing in many families. In the 50s a range of 3D films were being produced. In 1952 “Bwana Devil” by United Artists was shown across the USA. This was the first 3D film of the 50s. The film was shot with a process called Natural Vision. This procedure was pitched to Hollywood studios but they passed. A year later, in 1953, “House of Wax” was released in 3D. “Dial M for Murder” was initially intended to be released in 3D, but Alfred Hitchcock chose to release the film in 2D to optimize profits. Not all movie theaters were equipped with the 3D technology. 3D movies were also being developed outside america. In 1947 The Soviet Union released their first full length 3D film, “Robinson Crusoe”.

In the 1960s a new technology named Space-Vision 3D was released. This technology took two pictures and printed them above each other on one strip. Unlike previous 3D technologies, it took one projector with a unique lens. This new technology eliminated the requirement to use two cameras to show 3D movies. Two camera systems were hard to work with, because it required that the two cameras were perfectly synced. The first movie to utilize this technology has been “The Bubble”. The film was panned by critics, but the 3D experience still attracted huge audiences. It became a profitable film, making the new technology ready for advertising to other studios.

In 1970, Allan Silliphant and Chris Condon developed Stereovision. This was a brand new 3D technology which put two pictures squeezed together side by side on one strip of 35 millimeter film. This technology utilized a special anamorphic lens which would widen the picture by means of a set of polaroid filters. The first film to be released in Stereovision was a softcore sex comedy called “The Stewardesses”. The film cost just $100,000 USD to create and it earned an amazing $27 million in North America.

In the early 1980s many films were released in 3D with the identical procedure as Space Vision. A few of the movies which were published were Amityville 3-D, Friday the 13th Part III, and Jaws 3-D. In the mid 1980s, IMAX started producing documentary films in 3D. IMAx’s 3D technology highlighted mathmatical correctness and this eliminated the eye shadow which was seen in previous 3D technologies. In 1986, Canada had developed the first 3D film that used polarized glasses. It was known as “Echos of the Sun” and was created for Expo 86.

Through the 1990s, many movies were released in IMAX 3D. The most successful IMAX 3D movie released in this time was “Into the Deep”. The first IMAX 3D fiction film, “Wings of Courage” was released in 1996.

During the 2000s, many major studio films were released in 3D. In 2003, James Cameron released Ghosts of the Abyss. This was the first full length 3D IMAX feature film. This film used the newest IMAX 3D technology called Reality Camera System. The technology used the newest HD video cameras and was designed by Vince Pace. This same technology has been used in “Spy Kids 3D: Game over”, “Aliens of the Deep”, and “The Adventures of Sharkboy and Lavagirl in 3-D”. In 2004 the first full length animated 3D film was released. It was known as “The Polar Express”. This film was so successful in 3D that it prompted an excellent interest in 3D animated movies. The 3D version of the film earned 14x as much per display as the 2D version. In 2005, The Mann’s Chinese 6 theater in Hollywood became the first commercial movie theater to have the Digital 3D technology. In 2007 Scar 3D was released internationally and it was the first movie to be filmed using an entirely digital workflow.

Outdoor Solar Lighting – The Solar Benefits

Have you ever heard of lights? Well, if not, they’re essentially light fixtures that don’t use electricity. They’re powered by the sunlight through the use of solar rechargeable batteries. Basically they can be used inside (with a solar panel attached to the exterior of the home) or outside. These lights are the perfect choice to enhance the appearance of your home (indoors or outdoors) or just put in them to save money on your electric bills. The outdoor solar light is also great for people who enjoy outdoor recreational activities, have remote buildings, have cottage, enjoy camping, etc.. Even when there’s no electricity available, these lights will keep on shining. Many residences in remote areas in Africa and China are discovering, for the first time the benefits of having light after the sun goes down at night. It’s something that we take for granted but for them it’s a valuable gift.

Now, let us discuss the advantages of utilizing outdoor solar lighting. The following are Mentioned Advantages that you can get from Selecting solar lights:

Will save you money – Utilizing outdoor solar lighting will save you money in comparison with the traditional electrical light fixtures. If you use outdoor lights for safety and enjoy having a well lighted lawn, the switch to solar panels will provide a dramatic decrease in your monthly electricity bill. Yes, it might not come as cheap as buying electric powered lights, but in the future you may recover the gap, many times over, through your savings on your electricity bills.

Provides you light when nobody can – Lets say you have an area where there are no electrical outlets. It would need a skilled handy man or contractor and plenty of money to wire the area for power. But with outdoor solar lighting, you just identify the place where you want the lighting, secure the lighting with a stake in the ground, attach to your wall, the fence or a rod and instantly light will be available for the night hours. And, lots of the new solar lights give light equal to electric lights but with no recurring power bills.

Effortless to install – everyone knows that figuring out the electric system in our house isn’t straightforward. But outdoor solar lighting requires just a few minutes to install and requires no special skills. Just push the stake from the ground and the light is prepared to extend the lighting with no need for wiring or linking to a special power supply. For high intensity lights, there’s often a separate solar panel which may be attached to a stake nearby or attached to the side of a building or a rod and the lighting supplied is often equivalent to a lot of conventional lighting choices.

Safe to use if you’re concerned about the environment or the protection of your family members, then this is an exceptional option. Not only do you not need to change your bulbs regularly, since the solar LED has a normal life expectancy of about 20 years, but there are not any dangerous wires to contend with. It’s quite simple to install since there’s absolutely not any need to be worried about putting these lights near an electric outlet. And, you can remove running dangerous extension cords to the places where the light is necessary. This enables installation without fear of personal security and eliminates the possibility of tripping over wires and electric shocks from wiring difficulties.